A commonly used standard to quantify finished quality of elevated and slabon- ground slabs is the ASTM Standard E The procedure outlines the method of . slab-on-ground slabs is the ASTM Standard, ASTM E The procedure outlines the method of profiling finished concrete to determine the flatness (FF) and. ASTM E Standard Test Method for Determining FF Floor Flatness and FL Floor Levelness Numbers.
|Published (Last):||28 August 2017|
|PDF File Size:||14.52 Mb|
|ePub File Size:||4.50 Mb|
|Price:||Free* [*Free Regsitration Required]|
Module Floor Flatness and Level ASTM E with BuildIT Construction – FARO® Knowledge Base
Select a start point and then select an end point for the first line. Construct a polygon line around the area shown below. D1155 Version s – view previous versions of standard. No other units of measurement are included in this standard.
In those instances when the traffic across a floor will be confined to specific paths, however, the requirement for random sampling is eliminated, since the floor can indeed be inspected exactly as it will be seen by all of the traffic. Repeat for atm runs, as shown above. In these special cases, rather than inferring the condition of the traffic paths from a random sample, it is far more useful to measure each of the traffic ee1155 directly using continuous recording floor profilometer configured to run exactly in the traffic wheel paths.
Split cloud down to the area to be analyzed.
A complete metric companion to Test Method E has been developed, Test Method EM ; therefore, no metric equivalents are shown in this test method. Create Lines for Awtm Run Next we will create a line for each run, the end result will appear as shown: Line Panel for each completed line.
Module 6.2: Floor Flatness and Level ASTM E1155 with BuildIT Construction
Use the defaults for this exercise. These notes and footnotes excluding those in tables and figures shall not be considered as requirements of this test method.
Next we will create a line for each run, the end result will appear as shown: By now you should have a grasp of the following:.
A simple w orkflow from importing the files to producing a report of the surface deviation analysis. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Generate a Report from the Analysis The command will automatically ashm a standard report. To avoid errors, save the current project before attempting the Floor Flatness Analysis.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Click on the Report tab and click on Generate Report. Link to Active This link will always route to the current Active version of the standard. Tutorial Download If you would like to download the file used in this article, download the accompanying Training Data and extract its contents to a folder on your PC.
Split cloud Creating lines representing a run. Such direct simulation measurements eliminate the inherent uncertainties of statistical sampling and provide profile information immediately applicable to the correction of the surface in way of the future traffic.
Lines are created to represent runs with traditional equipment. If you would like to download the file used in this article, download the accompanying Training Data and extract its contents to a folder on your PC.
By now you should have a grasp of the following: A simple workflow from importing the files to producing a report of the surface asym analysis. When prompted specify a location and name for the PDF report. Select all the sample lines. When the traffic patterns across a floor are random, as is generally the case evaluation of the floor’s F F Flatness and F L Levelness will necessarily involve a random sampling of the surface, since all of the infinite potential profiles to be seen by the traffic can e1155 possibly be measured.