Buy now the Beyma 18LX60 18″ Watt AES 8 Ohm LX60 Series Long Excursion Bass Car Woofer and take advantage of our low prices and Free Shipping. (34) 96 13 75 · Fax (34) 96 15 07 · · E-mail: [email protected] ·. 18LX60V2. LOW FREQUENCY TRANSDUCER. Subwoofer Beyma 18LX General specifications: diameter 18 inches, maximum power W. Thiele-Small parameters: frequency of self resonance Fs=
|Published (Last):||26 November 2014|
|PDF File Size:||20.89 Mb|
|ePub File Size:||20.22 Mb|
|Price:||Free* [*Free Regsitration Required]|
This page was generated in 0. I’ve heard but can’t reference, so don’t take my word for it that the iPhone mic isn’t any good above dB.
I am a noise artist. I have a friend who does the noise thing. Do you have any weighting on the meter?
I built this cabinet to fit in the backseat of my car. As others have suggested, perhaps the wiring of all four drivers is out of polarity somewhere, causing cancellations in output between the speakers. Voice Coil Overhang Xmax.
Make sure the voltage at the amp is not dropping below This might be the problem. The wiring appears to be accurate. If you have a meter reading “C” scale, then you’re getting pretty much an accurate reading at lower frequencies, and something is going on elsewhere. Thanks for the responses. Please login or register. I have a question. Volume Displaced Heyma Driver.
Beyma 18LX60 Subwoofers
Joseph Metoyer wrote on Wed, 14 April Any other recommendations on a box design for this driver, or other opinions on this driver? Heres the specs Specifications. I’m new to this board. Or you could have a problem with the way you are measuring it.
Scott, Everyone has a duh moment,Shaw Edit: Mounting Information Overall Diameter I have a few different drivers available, just trying to 18lxx60 out what of them could be used for kick bins.
You might have a problem with your wiring and they are not working together. However, I am not sure if that is really the case and I don’t know what to do about it. Joseph Metoyer Newbie Offline Posts: Pick the one the matches or closely matches the TS Parameters of your driver and, there liee your answer.
Separate chambers will keep the cones from modulating each other, which will clean things up and allow proper tuning for the different speakers. Surface Area of Cone Sd m2. Also, the meter used in testing is probably “Weighted”, with an “A” or “B” rating, and the difference being a roll off in the lower 18l6x0 is introduced.
I can imagine it’s pretty demanding on gear! I have noticed that the speakers do seem as if they are fighting each other.
Beyma 18 LX 60 | music store
If it sounds like a gorilla is trying to escape, turn it down. Are you measuring the spl from 1 meter away and using beymaa frequency within the speaker’s range?
Are you using a peak response meter or some sort of slow or fast response meter? Joseph Metoyer wrote on Thu, 15 April